| Cryogenic pressure regulator Type B is a fully automatic valve designed for cryogenic service in the pressure build-up circuit. Because it can be used for either cryogenic liquids or gases, it may be installed either before or after the pressure build-up coil. | Cryogenic, water, air, light oil and steam | TecSheet B | $List Prices |
| Cryogenic pressure regulator designed for use in the pressure build-up circuit and maintains a relatively constant pressure differential across the valve even during high flow rates. Also available for inline gas service. |
Cryogenic liquids or gases |
TecSheet E-55 | $List Prices |
| Cryogenic pressure regulator designed for use in final-line gas circuit and maintains a relatively constant pressure differential across the valve even during high flow rates. Not to be used on cold gases or liquids with temperatures less than 0 degrees F = final line gas service only above 0 degrees F (255 degrees K). | Cryogenic liquids or gases | TecSheet E-55 for final line gas service |
$List Prices |
| Cryogenic liquids or gases | TecSheet FR-6 | $List Prices | |
| The Type FRM is designed to function as a Back Pressure or Economizer valve in Cryogenic Circuits. The Back Pressure Function is to open at a preset pressure and relieve inlet pressure to the discharge side into a lower pressure. The Economizer function is to open at a preset pressure, above the Pressure Build set pressure, and continue to open as gas head pressure from heat leak builds during non-use periods of the system. The Economizer by-passes gas head pressure directly to the Final Line circuit, when system draw resumes, to draw down the excess pressure rapidlyand recloses before the Pressure Build regulator opens. The Type FRM valve is small and compact, yet is highly efficient making it suitable lor numerous applicationsthat call for a small, accurate back pressure regulator. TheType FRM incorporates a "floating ring" design that provides for smooth even pressure control. Maximum Temperalure: +150 degrees F (339 degrees K) to -320°F (78°K). Maximum set pressure 600 psi. | Cryogenic liquids or gases | TecSheet FRM, TecSheet FRM-2 |
$List Prices |
| The Type G-60 regulator is a fully automatic pressure regulating valve designed for cryogenic service in the pressure buitd-up circuit. Because it may be used for either cryogenic liquids or gases, it may be installed either before or after the pressure build-up coil. Pressure reducing or pressure build up service. | Cryogenic liquids or gases | TecSheet G-60 | $List Prices |
| Wheel The Type LTC temperature control valve is a double-port valve with an adjustable temperature range of O degrees F to -40°F (255 degrees K to 233 degrees K). The Type LTC is reverse acting (closing at the adjusted minimum gas temperature) and subject lo ambient temperature under normal conditions: therefore, it will normally be in a wideopen position. In the event of valve failure, the valve will fail in the closed position. NOTE: Under normal operating condltlons, valve seat closure may take several seconds. | Cryogenic liquids or gases | TecSheet LTC | $List Prices |
| The Type PBE-1 regulator is designed for cryogenic service and combines the pressure building and economizer functions into one unit. In the Type PBE-1, the economizer function starts before the pressure build function stops. A restriction orifice limits the economizer output and prevents it from overpowering the pressure build function. The Type PBE-1 is small and compact, yet is highly efficient making it suitable for use in numerous applications. The Type PBE- 1 incorporates a 'floating ring' design that provides for smooth even pressure control. | Cryogenic liquids or gases that are NOT corrosive to brass | TecSheet PBE-1 | $List Prices |